[Spread-users] high cpu load

[George Schlossnagle]

Incidentally, how exactly did you run spread when it failed to run back
when?  If the ip of the hostname of the machine isn't in the file, it won't
run correctly unless you specify -n <name in spread.conf> on the command
line.


----- Original Message -----
From: "Michael Stiller" <ms@2scale.net>
To: <spread-users@lists.spread.org>
Cc: "Yair Amir" <yairamir@cnds.jhu.edu>; "Dirk Vleugels" <dvl@2scale.net>
Sent: Friday, August 31, 2001 11:28 AM
Subject: Re: [Spread-users] high cpu load


> Hi George,
>
> i'm working with Dirk on the same problem.
>
> Does it matter if we configured spread to use a multicast group which is
> on another interface as the ip addresses we used in the config file ?
>
> E.g.:
>
> Spread_Segment 224.0.224.1:4803 { # Multicast route is on eth1
>         cluster1        192.168.100.1 # IP Adress of eth0
>
> In the beginning we tried to use the "correct" ip address of
> eth1 but spread failed to run. Unfortunately i don't remember
> the error messages anymore.
>
> Cheers,
>
> -Michael
>
>
> _______________________________________________
> Spread-users mailing list
> Spread-users@lists.spread.org
> http://lists.spread.org/mailman/listinfo/spread-users
>