[Spread-users] high cpu load

[Michael Stiller]

Hi George,

i'm working with Dirk on the same problem. 

Does it matter if we configured spread to use a multicast group which is 
on another interface as the ip addresses we used in the config file ?

E.g.:

Spread_Segment 224.0.224.1:4803 { # Multicast route is on eth1
        cluster1        192.168.100.1 # IP Adress of eth0 

In the beginning we tried to use the "correct" ip address of
eth1 but spread failed to run. Unfortunately i don't remember
the error messages anymore.

Cheers,

-Michael