[Spread-users] high cpu load

George Schlossnagle george at omniti.com
Fri Aug 31 11:15:04 EDT 2001

----- Original Message -----
From: "Dirk Vleugels" <dvl at 2scale.net>
To: "Yair Amir" <yairamir at cnds.jhu.edu>
Cc: <spread-users at lists.spread.org>
Sent: Friday, August 31, 2001 11:00 AM
Subject: Re: [Spread-users] high cpu load

> Hi,
> On Fri, Aug 31, 2001 at 10:29:13AM -0400, Yair Amir wrote:
> > On a one segment network, unicat retrans are ALWAYS go only to the
> > daemon immediately before (in a circular fashion) the one that reports
> > sending the u retrans. That is why I asked to see all of the reports
> > and not only from one machine.
> Ok, these are status messages from all cluster members, two samples with
> a delta of 10 seconds. cluster2 has a very low 'u retrans' count, i have
> no clue why.
> cluster1:
> Status at cluster1 V 3.16. 0 (state 1, gstate 1) after 1109946 seconds :

This (all of whihc I deleted) seems to suggest that all the hosts are

Can you run s->r from each host in your spread.conf to the next host.  So if
you conf file is


then run s&r

a->b, b->c, c->a



More information about the Spread-users mailing list