<br><font size=2 face="sans-serif">Hi,</font>
<br>
<br><font size=2 face="sans-serif">I am new to spread and am trying to
setup spread on two test systems. Both the systems are on the same network</font>
<br>
<br><font size=2 face="sans-serif">The Spread_Segment section in the spread.conf
file on both the systems is as below</font>
<br>
<br><font size=2 face="sans-serif">Spread_Segment 157.227.25.255:4803
{</font>
<br>
<br><font size=2 face="sans-serif"> machine1
157.227.25.201</font>
<br><font size=2 face="sans-serif"> machine2
157.227.25.229</font>
<br><font size=2 face="sans-serif">}</font>
<br>
<br><font size=2 face="sans-serif">Spread executes successfully on the
machine2 , however the execution of spread on the machine1 fails with the
following error in testlog</font>
<br>
<br><font size=2 face="sans-serif">Conf_init: My proc id (157.229.25.201)
is not in configuration</font>
<br><font size=2 face="sans-serif">Exit caused by Alarm(EXIT)</font>
<br>
<br><font size=2 face="sans-serif">Please note the ip address <b>(157.229.25.201)
</b>in the error message. This is different form the actual ip address
<b>(157.227.25.201)</b> which is mentioned in the conf file.</font>
<br>
<br><font size=2 face="sans-serif">From the previous postings, I had a
feeling that using different port number may solve the problem, I
have tried using other ports as well but have been unsuccessful so far.
I am unable to understand how is the ip address 157.229.25.201 being picked
up.</font>
<br>
<br><font size=2 face="sans-serif">Any help on this would be greatly appreciated.</font>
<br><font size=2 face="sans-serif"><br>
Ashish Chaturvedi<br>
Tata Consultancy Services<br>
Mailto: ashish.chaturvedi@tcs.com<br>
Website: http://www.tcs.com</font>