[Spread-users] Leader issue

Yair Amir yairamir at cs.jhu.edu
Thu Aug 8 14:54:44 EDT 2019


Hello,

It seems that the daemons cannot communicate with each other.

Are you putting both in a single segment with multicast or broadcast address to connect that segment?
If so, it is likely that they cannot receive or send broadcast or multicast messages between them and that should be fixed for these computers.

In any case, it can be a firewall issue as well, where udp messages on the specific ports used are blocked.

Best wishes,

     :) Yair.  www.cs.jhu.edu/~yairamir

On 8/8/19 12:41 PM, Mary Henrikson wrote:
> I have been using spread for quite a while.   I am trying to change from old servers to new.   I’m using two nodes and each works independently but not together.   When I run the monitor tool they both show as being the leader.   They can telnet to each other so the port is open and they are using the same spread.conf file.    Anyone got
> Any ideas?
>
> Sent from my iPhone
> _______________________________________________
> Spread-users mailing list
> Spread-users at lists.spread.org
> http://lists.spread.org/mailman/listinfo/spread-users




More information about the Spread-users mailing list