[Spread-users] spread-src-3.17.3: "Conf_init: My proc id (10.10.10.46) is not in configuration"

[Serge Aleynikov]

Change segment config to this (where hostname is the name of your host), 
and restart spread using "-n" directive: spread -n hostname

Spread_Segment  10.10.10.255:2211 {
     hostname 10.10.10.46
}

Serge

Li, Grant wrote:

> Hi,
>  
> I have difficulty to start Spread daemon on a Solaris 2.7 box. The error 
> message is shown above.
>  
> The entries in the spread.conf are:
>  
> <config start>
> Spread_Segment  10.10.10.46:2211 {
>     localhost       127.0.0.1
> }
> DebugFlags = { ALL PRINT EXIT }
> EventLogFile = testlog.out
> EventTimeStamp = "[%a %d %b %Y %H:%M:%S]"
> DangerousMonitor = false
> #SocketPortReuse = AUTO
> #RuntimeDir = /var/run/spread
> #DaemonUser = spread
> #DaemonGroup = spread
> <config end>
>  
> Spread daemon was started by the following command:
> $ Spread -c spread.conf
>  
> The error messages are:
>  
> [Fri 06 May 2005 10:05:58] disabling Dangerous Monitor Commands!
> [Fri 06 May 2005 10:05:58] Finished configuration file.
> [Fri 06 May 2005 10:05:58] Conf_init: My proc id (10.10.10.46) is not in 
> configuration
> Exit caused by Alarm(EXIT)
>  
> Any help would be greatly appreciated.
>  
> Thanks
> Grant Li
> CSG Systems, Inc.
> (402)431-7515